Introduction: Anycubic Photon Filtration System

Engineerable along YouTube posted a video a while ago on his filtration system of rules for his anycubic photon. Today I am leaving to show you my remix of it. This has not been tested due to it's location and ME needing to fix astir the location first before I go ahead and use it only I have talked to umpteen industry experts connected this subject and I fail to understand how this would not work because I have went ahead and did in a higher place and beyond their suggestions.

I have a Anycubic Photon Zero. This printer does not have any power whatever without cutting holes in it for adding a ventilation system. Thusly I went forward and figured out a way for this printer to print without the hood along it internal a server gouge that is being filtered.

The filter I used is the same filter engineerable victimised in his video but I deliver the 4" interpretation which means that information technology is meant to embody affixed to a 4" duct. Not only that mine is very much smaller than his which means that mine will probably break quicker as substantially.

This enclosure is designed to be used inside and to be filtrated plenty it will be odorless for around a yr.

Enjoy!

Supplies

You will need the following supplies.

  1. Green house filter for a 4" duct. ($30)
  2. A waiter gouge with minimally space for 2 * 120mm fans on the top or sides of IT. Non only that it has to be large decent to hold the printer. ($200)
  3. Three fan mount prints for 4" duct.($0)
  4. 4" ducting and three ties for the ducting.($20)
  5. Duct tape measure. ($5)
  6. ATX 24v psu. ($10)

Whole tone 1: the Server Rack

  1. Tack together the server rack that fits your printer. IT must contain plenty distance for a 12" diam filter likewise.
  2. Cover whatever holes that could leak gentle wind with duct tape. You preceptor't want gentle wind to lam. Make a point power cables and pass the duct tapeline.
  3. Put the 120mm fans onto the rack with two mounts along top and one mount underneath. Attain sure that they are functioning as one being a inlet and the unusual being an way out by look the blades. The fans should only be healthy to bobble air one way properly.
  4. Connect the fans unitedly with ducts on go past with help from the steel ties.
  5. Unite the filter to the bottom ducting mountain with a piece of ducting and a tie. Doesn't matter if the separate out is beingness attached to a inlet or a mercantile establishment.

Dance step 2: Power

  1. Stick the psu onto the box with double sided sticky tape. DO NOT Accept ANY METAL FROM THE PSU Surgery COPPER FROM THE WIRES Moving THE ENCLOSURE FOR THAT WOULD Equal ASKING FOR TROUBLE!
  2. Connect positive outputs from the psu to a on polish off switch.
  3. Connect the output from the on off switch to positive on the sports fan.
  4. Connect ground to ground on the psu.
  5. Splice a power cable and connect information technology to the appropriate places along the psu based on the color of the wires.
  6. Test to attain sure it works.

Step 3: Closing!

In say to use the filtration organization you must print without the hood on the printer. Or just use the fumigate thug and take it off after you are done printing and look ten or 20 minutes for the fumes to dissipate. This is only with the anycubic photon nix. Another printer may not deman this. The filtration system only works with the power on obviously.

This should theoretically closing a long clock time without much need for maintenance. The filters don't most recently forever though so make up reliable to replace them as needed. They wear out with use.

I hope you enjoyed this instructable and to let me know what you think in the comments.

Thanks!

Be the First to Plowshare

Recommendations

  • Anything Goes Contend 2022

    Anything Goes Contest 2022